Component Testing
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
Rear Windshield Washer Pump
- Ignition OFF, disconnect the harness connector at the G24 Windshield Washer Pump.
- Install a 20 A fused jumper wire between one of the control terminals and 12 V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times.
- Verify the G24 Windshield Washer Pump activates.
- If the G24 Windshield Washer Pump does not activate.
Replace the G24 Windshield Washer Pump.
- If the G24 Windshield Washer Pump does activate.
- If the G24 Windshield Washer Pump does not activate.
- All OK