Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

With the aid of an assistant, load the instrument panel lower trim panel (1) to the tie bar.

Fig 1: Instrument Panel Lower Trim Panel
Courtesy of GENERAL MOTORS COMPANY
Reposition the instrument panel wiring harness into the vehicle position as was noted in the removal and connect the fasteners securing the instrument panel wiring harness to the instrument carrier.
Install the instrument panel lower trim panel screws (1) on the right side of IP.

Fig 2: Instrument Panel Lower Trim Panel Screws And Right Side Of IP
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Install the instrument panel compartment door latch striker bolt (1) and tighten to 9 N.m (80 lb in).

Fig 3: Instrument Panel Compartment Door Latch Striker Bolt
Courtesy of GENERAL MOTORS COMPANY
Install the instrument panel lower trim panel screws (1) on the IP compartment side.
Install the instrument panel lower trim panel nuts (2) and tighten to 9 N.m (80 lb in).

Fig 4: Instrument Panel Lower Trim Panel Screw And Nuts
Courtesy of GENERAL MOTORS COMPANY
Install the instrument panel lower trim panel screw (1) on the center of the IP.
Install the instrument panel lower trim panel screws (1) on the driver leg room.

Fig 5: Instrument Panel Lower Trim Panel Screws And Driver Leg Room
Courtesy of GENERAL MOTORS COMPANY
Install the instrument panel lower trim panel screws (1) on the left side of the IP.

Fig 6: Instrument Panel Lower Trim Panel Screws And Left Side Of IP
Courtesy of GENERAL MOTORS COMPANY
Install the instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement .

Fig 7: Instrument Panel Upper Trim Panel
Courtesy of GENERAL MOTORS COMPANY