LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Controls And Fuel - 1.4L (LV7) - Repair Instructions) >> Repair Instructions >> Fuel Tank Filler Pipe Replacement (32L (8.5 US Gallon) Tank) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel tank filler hose (1) to the fuel tank filler pipe (2).
    Fig 1: Fuel Tank Filler Hose
    GM4013996Courtesy of GENERAL MOTORS COMPANY
  2. Install the fuel tank filler pipe (2) to the tank.
    Fig 2: Fuel Tank Filler Pipe And Clamp
    GM4078846Courtesy of GENERAL MOTORS COMPANY
  3. Install the fuel tank filler hose clamp (1, 4).
  4. Install the fuel tank filler pipe bracket bolt (2). Tighten the bolt to 3 N.m (27 lb in).
    CAUTION: Refer to Fastener Caution .
  5. Install the fuel tank filler pipe ground (1).
    Fig 3: Fuel Tank Filler Pipe Ground And Bolt
    GM4013990Courtesy of GENERAL MOTORS COMPANY
  6. Install the fuel tank filler pipe ground bolt (2). Tighten the bolt to 9 N.m (80 lb in).
  7. Install the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
  9. Install the 3 fuel tank filler pipe bolts (1). Tighten the bolt to 6 N.m (53 lb in).
    Fig 4: Fuel Tank Filler Pipe Bolts
    GM4013970Courtesy of GENERAL MOTORS COMPANY
  10. Close the fuel filler door and filler cap.
scientia non olet · About LEMON Manuals