LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Controls And Fuel - 1.4L (LV7) - Repair Instructions) >> Repair Instructions >> Engine Oil Pressure Sensor Replacement (L5Q) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine oil pressure sensor (2) to the engine and tighten to 35 N.m (26 lb ft).
    Fig 1: Engine Oil Pressure Sensor Connector
    GM4035063Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
  2. Connect the engine oil pressure sensor connector (1).
  3. Install the transmission mount bracket bolt (1) and transmission mount bracket (2) and tighten to 22 N.m (16 lb ft).
    Fig 2: Transmission Mount Bracket Bolt
    GM4035060Courtesy of GENERAL MOTORS COMPANY
  4. Connect the 2 engine master harness wiring harness retainer (1) and evaporative emission canister purge solenoid valve hose.
    Fig 3: Engine Master Harness Wiring Harness Retainers
    GM4035055Courtesy of GENERAL MOTORS COMPANY
  5. Install the engine control module. Refer to Engine Control Module Replacement .
scientia non olet · About LEMON Manuals