Rear Bumper Fascia Replacement

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Bumper Fascia

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the tail lamps. Refer to Tail Lamp Replacement Remove the rear wheelhouse liner. Refer to Rear Wheelhouse Liner Replacement .
1	Rear Bumper Fascia Guide Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (20 lb in)
2	Rear Bumper Fascia Screw (Qty: 2) Tighten 1.8 N.m (16 lb in)
3	Rear Bumper Fascia Retainer (Qty: 2)
4	Rear Bumper Fascia Procedure Unclip from rear bumper fascia guides. Pull forward to remove the rear bumper fascia. Disconnect any electrical connectors. Transfer parts as needed.