LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark ACTIV, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Camshaft Cover Removal (LV7) >> Camshaft Cover Components Removal

Camshaft Cover Components Removal

Fig 1: Exploded View Of Camshaft Cover Components (LV7)
GM4141654Courtesy of GENERAL MOTORS COMPANY
Camshaft Cover Components Removal

Callout Component Name
1 Positive Crankcase Ventilation Valve Bolt [2x]
    NOTE:

    Discard the bolts.

  1. Using a suitable tool, cut a slot in the tamper-resistant positive crankcase ventilation valve bolt heads.
  2. Remove the bolts with a flat-bladed tool and discard.
2 Positive Crankcase Ventilation Tube with Positive Crankcase Ventilation Valve - Fresh Air
NOTE:

Discard the tube and valve.
3 Camshaft Position Sensor Bolt
4 Intake Camshaft Position Sensor
5 Camshaft Housing Stud [2x]
6 Camshaft Position Sensor Bolt
7 Exhaust Camshaft Position Sensor
8 Vacuum Pump Seal
Special Tools 
EN-51096  Seal Remover
Equivalent regional tools: Special Tools .
9 Camshaft Cover Locating Pin [2x]
10 Camshaft Position Actuator Solenoid Valve Bolt
11 Camshaft Position Actuator Solenoid Valve
12 Camshaft Position Actuator Solenoid Valve Bolt
13 Camshaft Position Actuator Solenoid Valve
scientia non olet · About LEMON Manuals