Installation Procedure
- NOTE:
Valve stem oil seal sets will contain 2 different colored seals, black and green. The set of 8 seals that are green have to be installed to the exhaust valves.
Install NEW valve stem oil seal (2). Use the EN-46116 installer (1).
- NOTE:
Make sure that the valve springs and the valve spring retainers will be installed in their original position.
Install the exhaust valve spring (1), or the intake valve spring (3) and the upper valve spring retainer (2). Which valve spring is to be installed, depends on the installation progress.
- CAUTION:
The valve stem keys must correctly seat in the valve spring cap. Engine damage may occur by not installing properly.
Using the EN-50717-2 compressor, push down the valve spring retainer (1) and compress the valve spring (3) until the valve keys (2) can be inserted. Carefully insert the valve keys then, so that they are proper installed to the valve stem grooves.
- Carefully release the tension from the EN-50717-2 compressor.
- Inspect the valve keys and valve spring retainer for proper seat.
-
Repeat the procedure with the remaining valves and cylinders.
- Transfer the EN-50717-1 stands, EN-51511 plug and the EN-50717-2 compressor as needed.
- Take care that air pressure is always applied to the combustion chamber of the treated cylinder.
- Remove the EN-51511 plug from the injector bores.
- Remove EN-50717-1 stands and the EN-50717-2 compressor from the cylinder head.
- Install the hydraulic valve lash adjuster arm. Refer to Hydraulic Valve Lash Adjuster Arm Replacement (LV7) .
- Install the camshaft position actuator. Refer to Camshaft Position Actuator Replacement .
- Install the spark plug. Refer to Spark Plug Replacement (LV7) .