LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark ACTIV, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Intake Camshaft Replacement >> Removal Procedure

Removal Procedure

  1. Remove the camshaft position actuator. Refer to Camshaft Position Actuator Replacement .
  2. Fig 1: Identifying Intake Camshaft, Intake Camshaft Bearing Caps And Bolts
    GM4036772Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Many internal engine components will develop specific wear patterns on their friction surfaces

    Components MUST be separated, marked, or organized in a way to ensure installation to their original location and position. Take precautions in order to prevent interchanging of parts.

  3. Tag or mark each part immediately when removed. Indicate location, direction, or orientation when necessary.
  4. Loosen the 10 camshaft bearing cap bolts (1, 3), working from outside to inside in a spiral in steps of 1/2 turn.
    5. NOTE:

    Observe the markings on the bearing caps. Each bearing cap is marked in order to identify its location.

  5. Remove the 10 camshaft bearing cap bolts (1, 3).
  6. Remove the camshaft bearing front intake cap (2) and camshaft bearing cap (4).
  7. Remove the intake camshaft (5).
scientia non olet · About LEMON Manuals