LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark ACTIV, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement (L5Q) >> Removal Procedure

Removal Procedure

  1. Remove the camshaft cover. Refer to Camshaft Cover Replacement .
  2. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  3. Remove the generator. Refer to Generator Replacement .
  4. Remove the oil pan. Refer to Oil Pan Replacement (L5Q) .
  5. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  6. Install the engine support fixture. Refer to Engine Support Fixture .
  7. GM4036584Courtesy of GENERAL MOTORS COMPANY

    Remove the air conditioning evaporate hose assembly bracket nut (1) and set aside the air conditioning evaporate hose assembly bracket (2).

  8. Remove the engine mount bracket. Refer to Engine Mount Bracket Replacement .
  9. GM4235869Courtesy of GENERAL MOTORS COMPANY

    Carefully tap the coiled spring pins (1) out of the engine front cover and the engine block so that they fall out with a suitable tool.

  10. Fig 1: Identifying Engine Front Cover, Bolts, Stud And Hole Plug Components
    GM4036586Courtesy of GENERAL MOTORS COMPANY

    Remove the engine front cover bolts (2, 4, 5) and stud (3).

  11. Locate pry-points on the engine front cover to loosen the cover from the engine block.
  12. Remove the engine front cover (6).
  13. Remove the engine front cover hole plug (1).
  14. GM4036587Courtesy of GENERAL MOTORS COMPANY

    Install the EN-51096  remover, remove the crankshaft front oil seal (1) from the engine front cover (2) and discard the seal.

  15. Cleaning all sealing surfaces from the engine front cover and the upper oil pan.
scientia non olet · About LEMON Manuals