LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark ACTIV, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Engine Flywheel Replacement (LV7) >> Removal Procedure

Removal Procedure

  1. Remove the clutch pressure and driven plate. Refer to Clutch Pressure and Driven Plate Replacement .
  2. Remove the starter. Refer to Starter Replacement (without Start/Stop)Starter Replacement (LV7) .
  3. GM4036579Courtesy of GENERAL MOTORS COMPANY

    Install the EN-51760  holder (2), lock the flywheel via the starter ring gear.

  4. Install the starter bolt (1).
  5. GM3763307Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Crankshaft position sensor reluctor ring can fall easily and be damaged. Ensure the crankshaft position sensor reluctor ring not to fall out.

    Remove the 8 flywheel bolts (2).

  6. Remove the flywheel (1).
scientia non olet · About LEMON Manuals