LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark ACTIV, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (LV7) >> Removal Procedure

Removal Procedure

  1. Remove the drive belt. Refer to Drive Belt Replacement (LV7) .
  2. GM3686986Courtesy of GENERAL MOTORS COMPANY

    Install the EN-44226-1  remover (2) to the crankshaft balancer (1).

  3. Loosen the crankshaft balancer bolt (3) by counter holding the crankshaft balancer (1) with the EN-44226-1  remover (3) and suitable tool.
  4. Remove the EN-44226-1  remover.
  5. Remove the crankshaft balancer bolt.
  6. GM3686991Courtesy of GENERAL MOTORS COMPANY

    Install the EN-44226-5  protector (1) to the crankshaft (2).

  7. GM3952844Courtesy of GENERAL MOTORS COMPANY

    Install EN-44226-1  remover (2) and EN-44226-2  remover plate (3) onto the balancer (4).

  8. Install the EN-44226-3  remover screw (1) through the EN-44226-2  remover plate and against the EN-44226-5  protector.
  9. Counter hold the EN-44226-2  remover plate and turn the EN-51368  installer screw to remove the balancer.
  10. Remove the EN-44226  remover.
  11. Remove the crankshaft balancer (4).
  12. Remove the EN-44226-5  protector.
scientia non olet · About LEMON Manuals