LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark ACTIV, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (LV7) >> Installation Procedure

Installation Procedure

  1. GM4091235Courtesy of GENERAL MOTORS COMPANY

    Crankshaft Balancer (1) @ Crankshaft (2) - Install

  2. Make sure that the key is properly seated on crankshaft balancer notch.
  3. Install the EN-51368  installer (3).
  4. Install the crankshaft balancer by screwing the flange from EN-51368  installer.
  5. Remove the EN-51368  installer (3).
  6. GM3686986Courtesy of GENERAL MOTORS COMPANY

    Install and hand tighten the crankshaft balancer bolt (3).

  7. Install the EN-44226-1  remover (2) to the crankshaft balancer (1).
    8. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  8. Tighten the crankshaft balancer bolt (3) by counter holding the crankshaft balancer (1) with the EN-44226-1  remover (3) and torque wrench.
    1. First pass to 100 N.m (74 lb ft)
    2. Loosen the bolt to 360 degrees
    3. Final pass to an additional 180 degrees, using the EN-45059  meter
  9. Remove EN-44226-1  remover (2) from the crankshaft balancer (1).
  10. Install the drive belt. Refer to Drive Belt Replacement (LV7) .
scientia non olet · About LEMON Manuals