Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Locate the camshaft position actuator dowel pin (1).
Courtesy of GENERAL MOTORS COMPANY

Install the intake camshaft position actuator (2).

CAUTION:

NOTE:

Counterhold the camshaft with a suitable tool.

NOTE:

Install the intake camshaft position actuator bolt (1) and tighten to:
1. First pass to 20 N.m (15 lb ft)
2. Final pass to an additional 90 degrees using EN-45059 meter.
Courtesy of GENERAL MOTORS COMPANY

The marks (2) of the camshaft position actuators must be positioned approximately at the 12 O'clock position.
Courtesy of GENERAL MOTORS COMPANY

Loosen the bolt (2).
Loosen the bolt (5, 6).
EN 51691 timing chain retainer (1), (4).
Courtesy of GENERAL MOTORS COMPANY

Remove EN 51632 camshaft locking tool (1).
Check the position of the crankshaft, camshaft and camshaft position actuator.
Courtesy of GENERAL MOTORS COMPANY

Turn crankshaft 720 degrees in the direction of engine rotation by the crankshaft balancer bolt (2).
Adjust the engine to cylinder 1 top dead center (TDC) of combustion stroke. Set crankshaft in direction of engine rotation until the markings (1, 2) line up. Rotate at the crankshaft balancer bolt (3).
Courtesy of GENERAL MOTORS COMPANY

Install the EN 51632 camshaft locking tool (1).
If the EN 51632 camshaft locking tool (1) can be installed, the engine timing is properly adjusted.
Install the timing chain upper guide. Refer to Timing Chain Upper Guide Replacement .
Install the camshaft cover. Refer to Camshaft Cover Replacement .