LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Malibu LS >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Front Bumper Fascia Replacement >> Removal Procedure

Removal Procedure

  1. GM4217291

    Front Bumper Fascia Upper Molding(2, 3) - Remove - FRONT BUMPER FASCIA UPPER MOLDING REPLACEMENT

  2. Raise and support the vehicle.
  3. GM4833701
    NOTE:

    It will be necessary to turn the front tire to the left when working on the right side, and to the right when working on the left side. This is to gain access to the bolts.

    Remove the 4 wheelhouse liner bolts (1) from the right and left hand wheelhouse liners.

  4. Remove 3 wheelhouse liner screws (2) from the from the right and left hand wheelhouse liners.
  5. GM4232055

    Remove the 9 front underbody front air deflector bolts (1).

  6. GM4827726

    Front Bumper Fascia Bolt(1)- Left Side - Remove

  7. GM4827729

    Front Bumper Fascia Bolt(1)- Left Side - Remove

  8. GM4827731

    Front Bumper Fascia Bolt(1)- Right Side - Remove

  9. GM4827733

    Front Bumper Fascia Bolt(1)- Right Side - Remove

  10. GM4827735

    Carefully push a small nylon wedge between the fascia (1) and the fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia.

  11. GM4828069

    Front Bumper Fascia(1) - Remove

  12. Disconnect all electrical connectors.
scientia non olet · About LEMON Manuals