Brake System (Complete): Remove & Replace
WARNING: This page is about the Malibu L, which is a different variant/trim than selected.
Includes: Replace Calipers and/or Wheel Cylinders, Brake Shoes and/or Pads. Clean, lube and/or replace Brake Hardware as necessary. Inspect Master Cylinder, all Hoses and bleed Brake System. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All Wheels,w/Electronic Parking Brake | Includes: Perform ABS Automated Bleed procedure. | 3.4 | B | |
| All Wheels,w/Foot Operated Parking Brake | Includes: Perform ABS Automated Bleed procedure. | 3.0 | B | |
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each | 0.2 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Parking Brake Service Mode | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. Includes: Electronic Parking Brake System Calibration. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE: Calibrate: | ||||
| w/Electronic Parking Brake | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Front,Hub & Bearing Assy,One Side | 0.5 | B | ||
| Rear,Hub & Bearing Assy,One Side | 0.4 | B | ||