Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0685, P0686, P0687
The DTC runs when Ignition 1 signal voltage is greater than 11 V.
P0689
- DTC P0685 is not set.
- The engine controls ignition relay is commanded ON.
- Ignition 1 signal voltage is greater than 11 V.
- The DTC runs continuously when the above conditions are met.
P0690
- DTC P0685 is not set.
- The engine controls ignition relay is commanded OFF.
- The DTC runs continuously when the above conditions are met.
P1682
- The engine controls ignition relay is commanded ON.
- Ignition voltage is greater than 5.5 V.
- The DTC runs continuously when the above conditions are met.