Crankshaft Position Sensor Replacement

WARNING: This page is about a different variant/trim than selected.

Callout	Component Name
Preliminary Procedure Starter Replacement (LFX)Starter Replacement (LCV)
1	Crankshaft Position Sensor Fastener CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Crankshaft Position Sensor Procedure Disconnect the electrical connector. If NOT replacing the component, install a NEW seal. Perform the crankshaft position variation learn. Crankshaft Position Variation Learn

Callout

Component Name

Crankshaft Position Sensor Fastener

CAUTION:

Tighten
10 N.m (89 lb in)

Crankshaft Position Sensor

Procedure

Disconnect the electrical connector.
If NOT replacing the component, install a NEW seal.
Perform the crankshaft position variation learn. Crankshaft Position Variation Learn