Powertrain Mount Balancing - Lower
WARNING: This page is about a different variant/trim than selected.
- NOTE:
Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Loosen the front transaxle mount through bolt.
Loosen the rear transaxle mount through bolt.
- Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
- Tighten the rear transaxle mount through bolt to 100 N.m (74 lb ft).
Tighten the front transaxle mount through bolt to 100 N.m (74 lb ft).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .