Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE:

If replacing a cylinder head, oil gallery plugs may need to be transferred to the new cylinder head.

For cylinder head assemble. Cylinder Head Assemble
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do not use any sealing material.

Install the cylinder head gasket (3) to the block.
Install the cylinder head (2). Ensure the number 1 cylinder is at top dead center (TDC). The key on the crankshaft should be on top in the 12 o'clock position.
Fig 1: Identifying Cylinder Head Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

NOTE:
Always use NEW cylinder head bolts.

Install the cylinder head bolts.
1. Tighten the bolts in sequence to 30 N.m (22 lb ft).
2. Tighten the bolts an additional 190 degrees in sequence using the EN 45059 meter.
Install the exhaust valve rocker arm. Exhaust Valve Rocker Arm Replacement
Install the fuel pump. Refer to Fuel Pump Replacement .
Install the intake valve rocker arm. Exhaust Valve Rocker Arm Replacement
Install the exhaust manifold. Exhaust Manifold Replacement
Install the intake manifold. Intake Manifold Replacement
Refill the engine with NEW oil. Engine Oil and Oil Filter Replacement
Refill the coolant system. Cooling System Draining and Filling (Vacuum and Fill)Cooling System Draining and Filling (Static)