Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

NOTE:
Fasteners have adhesive patch and must be tightened to final torque within 5 minutes.

Install the automatic flex plate (2) and hand start NEW bolts (1).
Courtesy of GENERAL MOTORS COMPANY

To prevent crankshaft rotation, install EN-50792 automatic flex plate holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flex plate.
Fig 1: Automatic Transmission Flex Plate Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Tighten the NEW bolts evenly using the following procedure:
1. Tighten the bolts a first pass in sequence to 30 N.m (22 lb ft).
2. Tighten the bolts a final pass in sequence 40 degrees using the EN-45059 meter.
Remove EN-50792 automatic flex plate holding tool.
Install the transmission. Refer to Transmission Replacement .