Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
- Remove the catalytic converter. Refer to Catalytic Converter Replacement .
- Using a suitable jack stand, support the rear of the powertrain.
Remove the transmission mount to bracket through bolt (1).
Remove the transaxle brace bolt (1), then loosen bolt (2) until it no longer engages the transaxle.
- Remove the transaxle brace (3) with bolt (2) still retained in the brace.
Remove the transmission mount to transmission bolts (2).
Remove the rear mount to frame fasteners (1, 2), then remove the mount from the vehicle.