Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Using the outline made by the spray paint or marker, install the transmission mount to transmission bolts (2) and tighten to 100 N.m (74 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Install the transaxle brace (3) with bolt (2) seated in the brace.
Install the transaxle brace bolt (1) and tighten to 50 N.m (37 lb ft).
Tighten the brace bolt (2) to 100 N.m (74 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Install the transmission mount to bracket through bolt (1) and tighten to 100 N.m (74 lb ft).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Use NEW bolts only.

Install the rear mount to frame fasteners (1, 2) and tighten to 100 N.m (74 lb ft) plus 120 - 130 degrees.
Install the catalytic converter. Refer to Catalytic Converter Replacement .
Perform the Powertrain Mount Balancing - Lower procedure. Refer to the appropriate engine section.
Remove the jack stand.
Lower the vehicle.