Transmission Fluid Accumulator Pipe Replacement (Hybrid)

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the battery tray. Refer to Battery Tray Replacement .
1	Accumulator Bypass Valve Seal NOTE: Install a NEW seal.
2	A/Trans Auxiliary Fluid Accumulator
3	A/Trans Auxiliary Fluid Accumulator Bolt M8 x 30 (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 22 N.m (16 lb ft)
4	A/Trans Fluid Accumulator Pipe Seal (Qty: 2) NOTE: Install NEW seals.
5	A/Trans Fluid Accumulator Pipe
6	A/Trans Auxiliary Fluid Accumulator Bolt M8 x 30 (Qty: 2) Procedure Fasten pipe to accumulator and tighten bolt just enough to hold in place. Align pipe to case and tighten bolt just enough to hold in place. Check the transmission fluid level. Refer to Transmission Fluid Level and Condition Check . Tighten 22 N.m (16 lb ft)
7	A/Trans Auxiliary Fluid Accumulator Solenoid Connector Procedure Connect the connector.