LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Impala Premier, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 6T45 (MHG) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the park brake and chock the wheels.
  2. Remove the shift knob from the transmission control. Refer to Transmission Control Lever Knob Replacement .
  3. Remove the left front floor console extension panel. Refer to Front Floor Console Extension Replacement - Left Side .
  4. GM2897722Courtesy of GENERAL MOTORS COMPANY

    Disconnect the wiring harness (3) from the access plate.

  5. Remove the access plate fasteners (1), then the access plate (2) from the console.
  6. GM2897696Courtesy of GENERAL MOTORS COMPANY

    Disconnect the transmission range selector lever cable terminal (2) from the shift lever pin (3).

  7. Release the transmission range selector lever cable retainer (1) and remove the transmission range selector cable from the transmission control lever base (4).
  8. GM2897716Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission shift control fasteners (1).

  9. Remove the transmission shift control (2).
  10. Disconnect the electrical connector from the rear of the transmission control.