LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Impala Premier, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - 6T45 (MHG) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM1998841Courtesy of GENERAL MOTORS COMPANY

    Install the 3 input speed sensor seals (1).

  2. Install the input speed sensor (3).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the input speed sensor bolt (2) M6 x 23 and tighten to 12 N.m (106 lb in).
  4. GM1998829Courtesy of GENERAL MOTORS COMPANY

    Connect the input speed sensor electrical connector (1).

  5. Install the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement .
  6. Perform the service fast learn adapt procedure.
scientia non olet · About LEMON Manuals