Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Install the control valve body cover wiring connector hole seal (4).
Install the control valve body cover gasket (3) to the control valve body cover.
Install the control valve body cover (2).
Lower the transmission and remove the transmission jack.
Hand start the control valve body cover bolts (1).
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

NOTE:
Install all control valve body cover bolts and studs by hand then torque all bolts and studs in sequence.

Install the control valve body cover bolts. Tighten the bolts in sequence to 12 N.m (106 lb in).
Courtesy of GENERAL MOTORS COMPANY

Connect the control valve body TCM electrical connector (1), then clip the wiring harness to the cover.
Install the front transmission mount. Refer to Transmission Front Mount Replacement .
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Install the oil cooler inlet (1) and outlet (5) hoses to the retainer (2) on the control valve body cover.
Fill the transmission. Refer to Transmission Fluid Drain and Fill .
Install the battery tray. Refer to Battery Tray Replacement .
Check for leaks.