Auxiliary Fluid Accumulator Replacement

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Set the park brake and chock the wheels. Remove the battery tray. Refer to Battery Tray Replacement . Disconnect the range selector cable from the range selector lever. Refer to Range Selector Lever Cable Replacement .
1	A/Trans Auxiliary Fluid Accumulator Pipe Bolt (Qty: 2) NOTE: Check the fluid. Tighten 22 N.m (16 lb ft)
2	A/Trans Auxiliary Fluid Accumulator Pipe Procedure Fasten pipe to auxiliary accumulator and tighten bolt just enough to hold in place. Align pipe to case and tighten bolt just enough to hold in place.
3	A/Trans Auxiliary Fluid Accumulator Pipe Seal (Qty: 2) NOTE: Install a NEW seal.
4	A/Trans Auxiliary Fluid Accumulator Solenoid Connector Procedure Disonnect the connector.
5	A/Trans Auxiliary Fluid Accumulator Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 22 N.m (16 lb ft)
6	A/Trans Auxiliary Fluid Accumulator
7	Accumulator Bypass Valve Seal NOTE: Install a NEW seal.