Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Set the park brake and chock the wheels.
- Reposition the engine control module out of the way without disconnecting the electrical connector (s). Refer to Engine Control Module Replacement .
Disconnect the transmission range selector lever cable terminal (1) from the transmission manual shift lever pin.
- Press the locking tabs inward in order to release the transmission range selector lever cable (2) from the cable bracket.
- WARNING:
Hold the transmission range selector lever while removing or installing the lever retaining nut. Excessive torque on the manual shaft can damage the detent lever hub retainer which could allow the vehicle to roll when placed in the park position.
Remove the transmission range selector lever nut (1).
- Remove the transmission range selector lever (2).