Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0716
- DTC P0101 - P0103, P0121 - P0123, P0716, P0717, P0752, P0973, P0974 = Not set
- Accelerator Pedal Position Signal from Engine Control Module = Valid
- Engine Speed = 400 to 7, 500 RPM
- Engine Torque Signal = Valid
- Ignition Voltage = 9 to 32 V
- Vehicle Speed = Greater than 10 km/h (6 MPH)
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 5 s
P0717Condition 1
- DTC P0101 - P0103, P0717, P0722, P0723 = Not set
- Calculated Engine Torque = Greater than 50 Nm (37 lb ft)
- Engine Speed = 400 to 7, 500 RPM
- Ignition Voltage = 9 to 32 V
- Vehicle Speed = Greater than 16 km/h (10 MPH)
Condition 2
- DTC P0101 - P0103, P0717, P0723 = Not set
- DTC P0722 = Test Failed
- Calculated Engine Torque = Greater than 50 Nm (37 lb ft)
- Engine Speed = 400 to 7, 500 RPM
- Ignition Voltage = 9 to 32 V
- Vehicle Speed = Greater than 16 km/h (10 MPH)
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 5 s
P07BF, P07C0
- DTC P07BF, P07C0 = Not set
- Ignition Voltage = 9 to 32 V
Frequency the DTC runs = Continuously - After the running conditions are met