LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T40 (MNH MNK) Or 6T45 (MHG) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Control Lever Knob Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Transmission Control Lever Knob Retainer
    GM4572558Courtesy of GENERAL MOTORS COMPANY
  1. Install the transmission control lever knob retainer (1).
    2. Fig 2: Wiring Harness
    GM4572559Courtesy of GENERAL MOTORS COMPANY
  2. Reposition Wiring Harness (1)
    3. Fig 3: Transmission Control Lever Knob Retainer
    GM4572565Courtesy of GENERAL MOTORS COMPANY
  3. Guide the wiring harness through the transmission control lever knob retainer (1).
  4. Attach the transmission control lever knob extension (1) to the lever knob.
    5. Fig 4: Transmission Control Lever Boot
    GM4572566Courtesy of GENERAL MOTORS COMPANY
  5. Attach the transmission control lever boot (1) to the transmission control lever knob.
    1. Guide the wiring harness through the transmission control lever boot (1).
    2. Clip the upper boot ring (2) into the bottom of the transmission control lever knob.
    6. Fig 5: Transmission Control Lever Knob
    GM4666068Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    When installing the transmission control lever knob, a defined snap noise should be audible and a snap effect should be felt. After installation, check the retention of the transmission control lever knob by pulling it upwards with two hands and significant force in an attempt to remove it.

  6. Install Transmission Control Lever Knob (1) @Transmission Control Lever
  7. Shift the transmission control lever into "P" position
    8. Fig 6: Electrical Connector
    GM4422377Courtesy of GENERAL MOTORS COMPANY
  8. Connect Electrical Connector (1)
    9. Fig 7: Transmission Control Lever Boot, Lever Boot Bezel And Electrical Connector
    GM4666021Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The transmission control lever boot snaps to the lever boot bezel in four locations (arrows): two on the passenger side, one on the driver side, and one on the front side. Before pushing the transmission control lever boot into the lever boot bezel, ensure proper alignment along the edges to avoid visible gaps.

  9. Clip the transmission control lever boot (1) into the lever boot bezel (2).
  10. Release the parking brake.
scientia non olet · About LEMON Manuals