LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T40 (MNH MNK) Or 6T45 (MHG) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Lever Replacement >> Removal Procedure

Removal Procedure

  1. Set the park brake and chock the wheels.
  2. Remove the battery tray. Refer to Battery Tray Replacement .
    3. Fig 1: Automatic Transmission Range Selector Lever Cable Terminal & Shift Lever Pin
    GM2492632Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the transmission range selector lever cable terminal (1) from the transmission manual shift lever pin.
  4. Press the locking tabs inward in order to release the transmission range selector lever cable (2) from the cable bracket.
    5. Fig 2: View Of Transmission Range Selector Lever
    GM2001183Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.

  5. Remove the transmission range selector lever nut (1).
  6. Remove the transmission range selector lever (2).
scientia non olet · About LEMON Manuals