LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T40 (MNH MNK) Or 6T45 (MHG) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Manual Shift Detent Lever With Shaft Position Switch Assembly Replacement >> Removal Procedure

Removal Procedure

  1. Remove the automatic transmission range selector lever. Automatic Transmission Range Selector Lever Replacement .
  2. Remove the control valve body. Control Valve Body Replacement .
    3. Fig 1: View Of Manual Shift Detent Lever & Shaft Position Switch Assembly
    GM1998834Courtesy of GENERAL MOTORS COMPANY
  3. Remove the manual shaft detent lever hub pin (1) using a pry bar and pliers.
  4. Remove and DISCARD the manual shift shaft pin (5).
  5. Remove the manual shaft (2).
    6. NOTE:

    Disconnect the actuator rod (3) from the detent lever assembly. Do not remove the actuator rod from the transmission case.

  6. Remove the manual shaft detent (with shift position switch) lever assembly (4).
scientia non olet · About LEMON Manuals