LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> General Information >> OEM General Information >> Vehicle Diagnostic Information - Diagnostic Information And Procedures >> Diagnostic Information And Procedures >> Diagnostic Repair Verification

Diagnostic Repair Verification

NOTE:

After a repair has been made, some DTCs require the ignition to be turned Off and then back On before the scan tool function will clear the DTC.

  1. Ignition/Vehicle - Off
  2. Install any components or connectors that have been removed or replaced during diagnosis.
  3. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
  4. Ignition - On/Vehicle - In Service Mode
  5. Perform the following action: Clear the DTCs.
  6. Ignition/Vehicle - Off - For greater than 60 s
  7. Perform the Circuit/System Verification and verify the result ends with an All OK. - If available

    or

    If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not set. If the DTC sets or another DTC is present - Refer to: Diagnostic Trouble Code (DTC) List - Vehicle 

    or

    If the repair was symptom related, duplicate the conditions under which the customer concern occurred to verify the repair. If the customer concern reoccurs or another symptom is present - Refer to: Symptoms - Vehicle 

scientia non olet · About LEMON Manuals