When to Perform the Procedure
WARNING: This page is about a different variant/trim than selected.
NOTE:
Failure to perform this procedure may result in poor system performance, DTCs being set, or customer dissatisfaction.
This procedure is required when the following component has been repaired, replaced, removed, or serviced:
- B65 Intake Manifold Pressure and Air Temperature Sensor
- B74 Manifold Absolute Pressure Sensor
- B75B Mass Air Flow/Intake Air Temperature Sensor
- B75C Multifunction Intake Air Sensor
- B111B Turbocharger Boost/Intake Air Temperature Sensor
- Q38 Throttle Body
- Q40 Turbocharger Bypass Solenoid Valve
- Q42 Turbocharger Wastegate Solenoid Valve
- Intake Air Duct - Collapsed/Leaking/Loose/Restricted
- Turbocharger