LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 2.0L (LTG) - Repair Instructions) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Sensor 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Heated Oxygen Sensor
    GM4675841Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution .

  1. Use the J-39194  wrench to install the heated oxygen sensor (1) and tighten to 42 N.m (31 lb ft).
    2. Fig 2: Heated Oxygen Sensor Wiring Connector
    GM4675840Courtesy of GENERAL MOTORS COMPANY
  2. Connect the heated oxygen sensor wiring connector (1) to the engine wiring harness connector (2).
    3. CAUTION:

    Refer to Heated Oxygen Sensor Resistance Learn Reset Caution .

  3. If replacing, perform the HO2S heater resistance learned values reset. HO2S Heater Resistance Learned Values Reset 
scientia non olet · About LEMON Manuals