Conditions for Running the DTCs

WARNING: This page is about a different variant/trim than selected.

DTC P0010, P0011, P0013, P0014, P0016, P0017, P0033, P0034, P0035, P0068, P00C8, P00C9, P0111, P0112, P0113, P0114, P0116, P0122, P0123, P0128, P0222, P0223, P0236, P0237, P0238, P0243, P0245, P0246, P0601, P0604, P0606, P1682, P16A0, P16A1, P16F3, P2101, P2176, P2227, P2228, P2229, P2230 or P2261 is not set.
The driver requested boost pressure level exceeds the level of the base boost pressure.
The engine speed is between 1, 600 - 6, 000 RPM.
The desired boost pressure is between 140 - 300 kPa (20.3 - 43.5 psi)
The Barometric Pressure (BARO) is between 60 - 120 kPa (8.7 - 17.4 psi).
The Engine Coolant Temperature (ECT) is between -40 to +120°C (-40 to +248°F).
The Intake Air Temperature (IAT) is between -40 to +80°C (-40 to +176°F)
The turbocharger wastegate is not under output device control.
The turbocharger bypass valve is not under output device control.
The DTCs run continuously when the above conditions have been met.