LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0010 - P0333)) >> Diagnostic Information And Procedures >> DTC P0121, P0122, P0123, P0222, P0223, P16A0, P16A1, P16A2 Or P2135: Throttle Position Sensor/Sensor Communication Circuit >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components that have been removed or replaced during diagnosis.
  2. Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
  3. Clear the DTCs with a scan tool.
  4. Ignition OFF and all vehicle systems OFF. It may take up to 2 min for all vehicle systems to power down.
  5. Ignition ON.
  6. Verify the Throttle Position Sensors 1 and 2 parameter displays Agree while performing the Throttle Sweep Test with a scan tool.
    • If Agree is not displayed 

      Test or replace the Q38 Throttle Body Assembly.

    • Go to next step: If Agree is displayed 
  7. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not set.
    • Go to next step: If DTC does not set 
  8. All OK.