LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0010 - P0333)) >> Diagnostic Information And Procedures >> DTC P0102 Or P0103: Mass Air Flow (MAF) Sensor Circuit Frequency >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine idling, observe the scan tool MAF Sensor parameter at operating temperature. The reading should be between 2.5 - 5.5 g/s.
    • If not between 2.5 - 5.5 g/s 

      Refer to Circuit/System Testing below.

    • Go to next step: If between 2.5 - 5.5 g/s 
  2. Verify the scan tool MAF Sensor g/s parameter changes smoothly and gradually as the engine speed is increased and decreased while performing the actions listed below.
    1. Engine idling
    2. Increase the engine speed slowly to 3, 000 RPM and then back to idle.
    3. Review Stored Data
    4. Observe the MAF Sensor parameter frame by frame with a scan tool.
    • The MAF Sensor parameter does not change smoothly and gradually 

      Refer to Circuit/System Testing below.

    • Go to next step: The MAF Sensor parameter changes smoothly and gradually 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing below.

    • Go to next step: If the DTC does not set 
  5. All OK
scientia non olet · About LEMON Manuals