LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0010 - P0333)) >> Diagnostic Information And Procedures >> DTC P00EA, P00EB, P00EC: Intake Air Temperature (IAT) Sensor 3 Circuit >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON.
  2. Verify that DTC P0641, P0651, P0697, P06A3 or P06D2 is not set.
    • Go to next step: If none of the DTCs are set 
    3. NOTE:

    To minimize the effects of residual engine heat and sensor internal heating elements, perform Steps 3 and 4 of this verification procedure only if the ignition has been OFF for 8 hours or more.

  3. Ignition ON.
  4. Verify the following scan tool parameters are within 30°C (54°F) of each other.
    • Start-Up IAT Sensor 1
    • IAT Sensor 2
    • IAT Sensor 3
    • If not within 30°C (54°F) 

      Refer to Circuit/System Testing below.

    • Go to next step: If within 30°C (54°F) 
  5. Engine idling, verify the following scan tool parameters are between: -60 and +149°C (-76 and +300°F).
    • IAT Sensor 1
    • IAT Sensor 2
    • IAT Sensor 3
    • If not between: -60 and +149°C (-76 and +300°F) 

      Refer to Circuit System Testing below.

    • Go to next step: If between: -60 and +149°C (-76 and +300°F) 
  6. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  7. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing below.

    • Go to next step: If the DTC does not set 
  8. All OK
scientia non olet · About LEMON Manuals