LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0010 - P0333)) >> Diagnostic Information And Procedures >> DTC P0089, P00C6, P228C Or P228D: Fuel Pressure Regulator >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0089 

The high pressure fuel pump has exceeded it's control limits. This condition exists when the high pressure fuel pump actuator command is 0° or greater than 240°. The condition exists for greater than 10 s.

P00C6 

The ECM detects that the fuel rail pressure is not rising greater than 3 MPa (435 psi) or has fallen below 2 MPa (290 psi) during engine cranking, depending on initial pressure when cranking begins.

P228C 

The actual fuel rail pressure is 3 MPa (435 psi) less than the desired fuel rail pressure. The condition exists for greater than 10 s.

P228D 

The actual fuel rail pressure is 3 MPa (435 psi) greater than the desired fuel rail pressure. The condition exists for greater than 10 s.

scientia non olet · About LEMON Manuals