Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0030, P0031, P0032, P0036, P0037, P0038
- Engine Speed = Greater than 400 RPM
- Ignition Voltage = 11 to 32 V
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 5 s
P0053
- DTCs related to the following system/component = Not Set
- B34 Engine Coolant Temperature Sensor
- B111B Turbocharger Boost/Intake Air Temperature Sensor
- ECT Sensor & IAT Sensor = Within 8°C (14°F) of each other
- ECT Sensor = 30 to 255°C (86 to 491°F)
- Engine = Running
- Ignition Voltage = Less than 32 V
Frequency the DTC runs = Once - Per cold start-up - After the running conditions are met
P0135, P0141
- DTC P0116, P0117, P0118, P0119, P0128, P111E = Not set
- HO2S Heater = Device controls are not active.
- HO2S 1, 2 Heater Command = Greater than 0% Duty Cycle
- Ignition Voltage = 10 to 32 V
Frequency the DTC runs = 2 times - Per drive cycle - After the running conditions are met - For greater than 120 s
P103B, P103C
- Engine = Cranking or Running
- Ignition Voltage = 10 to 32 V
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 3 s