LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0010 - P0333)) >> Diagnostic Information And Procedures >> DTC P0011 Or P0014: Intake/Exhaust Camshaft Position System Performance >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the appropriate Q6 Camshaft Position Actuator Solenoid Valve.
  2. Test for 7 - 12 Ω between the control terminal 1 or A and the low reference circuit terminal 2 or B.
    • If not between 7 - 12 Ω 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • Go to next step: If between 7 - 12 Ω 
  3. Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
    • If less than infinite resistance 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • Go to next step: If infinite resistance 
  4. All OK
scientia non olet · About LEMON Manuals