LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (P0010 - P0333)) >> Diagnostic Information And Procedures >> DTC P0010, P0013, P2088, P2089, P2090, Or P2091: Camshaft Position Actuator Solenoid Valve Control Circuit >> Component Testing >> Static Test

Static Test

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Disconnect the appropriate electrical connector:Q6 Camshaft Position Actuator Solenoid Valve
  3. Test for 5 to 12 Ω between the test points:Control terminal 1/A & Low Reference terminal 2/B
    • If not between 5 to 12 Ω 

      Replace the component:Q6 Camshaft Position Actuator Solenoid Valve

    • Go to next step: If between 5 to 12 Ω 
  4. Test for infinite resistance between the test points:Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component:Q6 Camshaft Position Actuator Solenoid Valve

    • Go to next step: If infinite resistance 
  5. All OK.
scientia non olet · About LEMON Manuals