LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal And Valve Spring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Using the EN-37281-A  Valve Guide Seal Remover, install the NEW valve seal. Fully seat the seal onto the valve guide.
    2. Fig 1: Valve Spring, Keepers And Retainer
    GM2401713Courtesy of GENERAL MOTORS COMPANY
  2. Install the valve spring (3) and retainer (2).
  3. Compress the valve spring using the valve spring compressor.
  4. Install the valve spring keepers (1).
  5. Disconnect the air hose and air hose adapter.
    6. Fig 2: Valve Spring Compressor
    GM3942126Courtesy of GENERAL MOTORS COMPANY
  6. Remove the EN-50717  Valve Spring Compressor and EN-50717  Valve Spring Compressor adapter set from the cylinder head.
  7. Install the spark plugs. Spark Plug Replacement
  8. Install Valve Rocker Arm - Intake Valve Rocker Arm Replacement , Exhaust Valve Rocker Arm Replacement 
  9. Remove the EN-50792  Flywheel Holding Tool.
  10. If equipped with an automatic transmission, install the starter. Starter Replacement (LTG - All Wheel Drive)Starter Replacement (LTG - Front Wheel Drive)
scientia non olet · About LEMON Manuals