LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Powertrain Mount Balancing >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Lifting and Jacking the Vehicle
  2. Loosen the transmission front strut bolt at the transmission mount strut bracket. Transmission Mount Strut Replacement (All Wheel Drive)Transmission Mount Strut Replacement (Front Wheel Drive)
  3. Position two floor jacks with wood blocks under the engine and transaxle in order to support the powertrain assembly.
  4. Lower the vehicle. Lifting and Jacking the Vehicle
    5. Fig 1: Engine Mount Bracket Bolts
    GM4665540Courtesy of GENERAL MOTORS COMPANY
  5. Loosen ONLY the engine mount to engine mount bracket bolts (1). Engine Mount Replacement 
    6. Fig 2: Bolts At Left Transmission Mount
    GM4590313Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Only the transmission mount to transmission bolts should be loosened. Bolts (1) should remain tighten during the balancing procedure.

  6. Loosen bolts (2) at the left transmission mount (3). Transmission Mount Replacement (Left Side M3U)Transmission Mount Replacement (Left Side M3D/M3H)
scientia non olet · About LEMON Manuals