LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Oil Pan Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Drain the engine oil and remove the oil filter. Refer to Engine Oil and Oil Filter Replacement .
  2. Support the engine. Refer to Engine Support Fixture .
  3. Remove Drivetrain and Front Suspension Cradle Replacement (All Wheel Drive)
  4. Remove Oil Pump Flow Control Valve Heat Shield Replacement
  5. Remove the front engine cover (1). Refer to Engine Front Cover Replacement .
  6. Remove the exhaust front pipe. Refer to Exhaust Front Pipe Replacement (LTG) .
    7. Fig 1: Catalytic Lower Brace And Fasteners
    GM3923325Courtesy of GENERAL MOTORS COMPANY
  7. Remove the catalytic converter to oil pan brace fasteners (1).
  8. Remove the catalytic lower brace (2).
    9. Fig 2: Compressor Bolt
    GM3923334Courtesy of GENERAL MOTORS COMPANY
  9. Remove the bolt (1)
    10. Fig 3: Oil Pan To Transmission Fasteners
    GM3924569Courtesy of GENERAL MOTORS COMPANY
  10. Remove the oil pan to transmission bolts (1, 2)
    11. Fig 4: Electrical Connector And Bolt
    GM3923361Courtesy of GENERAL MOTORS COMPANY
  11. Disconnect the electrical connector (1)
  12. Remove the bolt (2)
    13. Fig 5: Oil Pan Bolts
    GM3924640Courtesy of GENERAL MOTORS COMPANY
  13. Remove the long oil pan bolts (3), medium bolt (2) and short bolts (1), then remove the oil pan.
  14. For part transfer, cleaning and inspection, refer to Oil Pan Cleaning and Inspection .
scientia non olet · About LEMON Manuals