LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Intake Valve Rocker Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Valve Tips
    GM1825091Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the valve tips. Refer to Adhesives, Fluids, Lubricants, and Sealers .
    2. Fig 2: Intake Rocker Arm
    GM2963895Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Used rocker arms must be returned to the original position on the camshaft. If the camshaft is being replaced, the rocker arms actuated by the camshaft must also be replaced.
    • Pre-oil roller bearings before installation.
  2. Lubricate the roller bearings with valve rocker arm lubricant. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  3. Position the valve rocker arm (1) on the tip of the valve stem and on the lash adjuster and lubricate. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  4. Install the camshaft position actuator and camshaft - intake. Refer to Camshaft Position Actuator and Camshaft Replacement - Intake .
scientia non olet · About LEMON Manuals