LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Balancer Shaft With Oil Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove Oil Pan Replacement (AWD) Oil Pan Replacement (FWD) 
  2. Remove Timing Chain Crankshaft Sprocket Replacement 
    3. Fig 1: Balancer Shaft with Oil Pump And Bolts
    GM4176256Courtesy of GENERAL MOTORS COMPANY
  3. Remove Balancer Shaft with Oil Pump Bolt (1) [8x]
  4. Remove Balancer Shaft with Oil Pump (2)
    5. NOTE:

    If replacing the oil pump, remove it from the balancer shaft.

  5. Remove the oil pump. Balancer Shaft with Oil Pump Disassemble 
scientia non olet · About LEMON Manuals