LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Special Tools

For equivalent regional tools, refer to Special Tools .

  1. Remove the transmission. Refer to Transmission Replacement (Front Wheel Drive except Diesel Engine)Transmission Replacement (All Wheel Drive except Diesel Engine) .
    2. Fig 1: Starter Motor Bolts
    GM2744964Courtesy of GENERAL MOTORS COMPANY
  2. To prevent crankshaft rotation, install the EN-50792  holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the automatic flex plate.
    3. Fig 2: Automatic Flex Plate Attaching Bolts
    GM2726718Courtesy of GENERAL MOTORS COMPANY
  3. Remove the automatic transmission flex plate attaching bolts (1).
  4. Remove the automatic transmission flex plate (2).
  5. Remove the EN-50792  holding tool.
  6. For automatic transmission flex plate cleaning and inspection, Refer to Automatic Transmission Flex Plate Cleaning and Inspection .
scientia non olet · About LEMON Manuals