LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - Off Vehicle >> Water Pump Removal

Water Pump Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Thermal Bypass Pipe Bolts And Gasket
    GM2769478Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the thermal bypass hose at the engine oil cooler.
  2. Remove the thermal bypass pipe bolts (1) at the water pump assembly.
  3. Disconnect the pipe from the water outlet assembly.
  4. Remove the thermal bypass pipe (2) and gasket (3) from the water pump assembly. Discard the gasket.
    5. Fig 2: Retaining Clip And Engine Coolant Temperature Sensor
    GM2726770Courtesy of GENERAL MOTORS COMPANY
  5. Remove the retaining clip (5) and engine coolant temperature sensor (2).
  6. Remove the water outlet assembly (1), bolts (4), and gasket seal (3). Discard the gasket.
    7. Fig 3: Thermostat Assembly And Gasket Seal
    GM2726772Courtesy of GENERAL MOTORS COMPANY
  7. Remove the thermostat assembly (2), bolts (3), and gasket seal (4). Discard the gasket.
  8. Remove the water pump assembly (5), bolts (1), and seal (6). Discard the seal.
scientia non olet · About LEMON Manuals